This Bottle Battery is great for making lightweight conversions, and fitting into tight spots that other larger batteries cannot. Featuring an on/off power button, USB port (for charging your mobile device etc.), and a locking cradle, these are typically installed on your downtube, but some people put them in a backpack with an extension, while others fit them inside a bike frame bag, place them on a rear rack, or in a pannier. If using with a recumbent/trike, they often work out nicely installed on the boom due to the small diameter and low weight. They also mount great on T-Cycle and other available Battery Mounts.
- This battery is 432 watt hours. On average riders use around 20-25 watt hours per mile. This is the perfect battery for approximately 20 miles, although with lower power/assist you may get up to 40 miles or so.
- This pack is suitable for lower power 48 volt systems that only require 18 amps max continuous discharge. We specifically pair this battery with our 48v TDSZ2 Models, but 48/52v BBS02 Models will also work fine if they are tuned down considerably to below 18 amps. Most 48v hub systems require a bit more power than this, but some smaller 48v hub systems are lower power and a good match as well - refer to your current setup's requirements to be sure.
- This Battery has a DC5521 Barrel Charge Port, and includes a 2 Amp Charger. The Discharge cable uses an XT90s Anti-Spark Connector. We also have adapters available if needed. As with all our products, this is covered by our Comprehensive Warranty and Extended Support Plan.
Highly Water Resistant Design
Power Button under Top Cap
USB Port under Top Cap (5v1a - for Charging a Mobile Device, Bluetooth Speaker, etc.)
DC5521 Barrel Plug Charge Port under Top Cap
Includes 48v (42v max) 2a Charger
4"+ Discharge Cable uses an XT90s Anti-spark Connector